Fire Alarm Annunciator Panel Usually Location

Author : ASNEWARE

Update time : 2022-10-19 16:17:35

Fire alarm annunciator panel is a fire alarm device that can be connected with the fire alarm control panel through the bus, and deal with the data sent by the control panel. fire alarm annunciator panel should be installed in the front room of the elevator, the public walkway, emergency access, or the stairwells.

The fire alarm annunciator panel, also known as the centralized warning panel or caution advisory panel, is a fire alarm device that can be connected with the fire alarm control panel through the bus, and deal with the data sent by the fire alarm control panel.

When the fire alarm control panel monitors several floors or fire compartments at the same time, you can install an fire alarm annunciator panel on each floor or fire compartment to replace the fire alarm control panel. Usually, the fire alarm annunciator panel includes warning indicators or audible signals to draw the attention of operating personnel to the fire alarm annunciator panel for urgent events.

How to decide on the installation position of the fire alarm annunciator panel? And what position is both suitable for installation and in accordance with the requirements?

The installation locations of the fire alarm annunciator panel are as follows:

1.The front room of the elevator

2.The public walkway

3.Emergency access, stairwells, etc.

The installation positions above are convenient for personnel to check and operate.

For the installation height of the fire alarm annunciator panel, you should follow the suggestions below:

1.When installed on the wall, the bottom of the fire alarm annunciator panel should be 1.3m-1.5m from the ground.

2.When installed on the side near the door, the fire alarm annunciator panel should not be less than 0.5m away from the wall.

3.When the fire alarm annunciator panel is operated from its front, the distance should not be less than 1.2m.

4.When installed near the ground, the bottom of the fire alarm annunciator panel should be 0.1-0.2m away from the ground.

ASENWARE offers fire alarm annunciator panels for fire alarm systems, like addressable fire alarm annunciator panels, to meet the different needs of customers, letting the relevant personnel know the location and information of the fire in time.

Previous : What is fire alarm system Encoder?

Next : How To Debugging Fire Alarm System

The floods are merciless, Asenware has love - fighting floods with Bangladesh

Sep .12.2024

Flood merciless, but there is love in the world. When Asenware knew Bangladesh was in the midst of a flood disaster, On September 6th, Asenware, with the support of local partners, Four different Bangladeshi charities: As-Sunnah Foundation, trustful trading LTD, Bangladesh Red Crescent Society, Chief Advisor's Relief and Welfare Fund are donated by Asenware,

What is Fire Hose?

Oct .13.2023

A fire hose is a highly pressurized hose that is used to bring water to the fire. It may also transport flame retardants. Fire hoses can be attached to either a fire engine or a fire hydrant, and the pressure is between 800 and 2000 kPa. For reasons of fire safety, it's quite important to have a fire hose inspection as well as all fire protection equipment tested. If, during a fire emergency, the fire hose fails it could have disastrous results.

What is Water-proof Fire Alarm System?

Sep .15.2023

Waterproof Heat Detector
Fixed Temperature Waterproof Heat Detector, the detector uses a bi-metallic strip to sense temperature change, therefore consuming minimal standby current and providing high reliability.
The Detector is particularly suited to environments, which are exposed to high levels of condensation or are hosed down. The detector has a wide operating margin allowing it to respond to both slow and fast increases in temperature; it can also sense temperature reliably in a horizontal or vertical position.

Addressable Explosion-proof Fire Alarm System Introduction

Aug .08.2023

The Explosion Proof range of products has been designed to provide protection against explosions and products to ensure that all major advantages of high-quality fire detection technology can be safely exploited in industrial and hazardous environments. Many difficult sites such as metal, paint, pipelines, chemical, pharmaceutical, oil refineries, and other installations are vulnerable to the risk of explosion. In order to protect the assets and people, they need special solutions for fast and reliable fire detection.

China-R&D and Supply Chain Center

Huoju District, Zhongshan City, Guangdong Province, China

Email us

[email protected]

Call us

0086 13922805301

About Us: About Us

Products: Fire Alarm System Emergency system Fire Suppression System Fire Fighting System

Contact Us

News: Company News Industry News Fire Alarm Devices Fire Alarm System Fire Detection Devices Fire Suppression System

Asenware email Asenware

Language

Language

Fire Alarm Annunciator Panel Usually Location